eLaws | eCases | Unannotated Code of Maryland and Rules | Maryland Courts | Counties & Cities of Maryland | Code of Federal Regulations | United States Code |
 Annapolis
 Code of Ordinances
 Title 21. PLANNING AND ZONING
 Division III. BASE DISTRICT REGULATIONS
 Chapter 21.50. BULK REGULATIONS TABLES

  § 21.50.130. Bulk Regulations Table C1-A District.  

Latest version.

  • Important. The notes at the end of the table are as much a part of the law as the table itself.

    Permitted uses,
    special exception
    uses, and uses
    subject to
    specific
    standards
    		Floor
    Area
    Ratio
    (maximum)
    		Density
    (maximum,
    expressed as
    minimum
    sq. ft. of
    lot area per
    dwelling
    unit)
    		Lot
    Dimensions
    (minimum)
    Area (sq. ft.
    or acres)
    		Lot
    Dimensions
    (minimum)
    Width (ft)
    		Yards
    (minimum)
    Front (ft)
    		Yards
    (minimum)
    Interior
    Side (ft)
    		Yards
    (minimum)
    Corner
    Side (ft)
    		Yards
    (minimum)
    Rear (ft)
    		Height
    (maximum,
    feet)
    Bed and breakfast homes 2.0 3,600 25 30
    Dwellings, single-family detached 2.0 3,600 25 30
    Dwellings, two-family 2.0 1,800 3,600 25 30
    Educational institutions Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24 Bulk regulations shall be determined through the site design plan review and/or planned development processes, pursuant to Chapters 21.22, and 21.24
    Governmental uses 2.0 10,000 70 30
    Museums and art galleries 2.0 20,000 90 30
    Religious institutions 2.0 10,000 70 30
    Accessory Uses
    Accessory buildings 2.0 Per the principal use Per the principal use 5 2
    Mooring slip No requirement No requirement No requirement No requirement

     

    Table Notes:

    1 Front yards are not required, except in the case of an established front yard pursuant to Chapter 21.38.

    2 Side yards are not required, but where a side yard is provided it shall be not less than five feet.

    3 Corner side yards are not required, except in the case where there is an established front yard in the remainder of the block. In those cases, the corner side yard shall be provided in accordance with the established-front-yard regulations pursuant to Chapter 21.38.

    4 In the historic district, special height measurement and limits requirements apply, see Chapter 21.56.

    5 Unless the entire accessory structure is located on the rear twenty-five percent of the lot, in which case only two feet is required. See illustration at Section 21.60.100.

    6 In the case of existing buildings, lot size and width requirements shall be determined through the special exception process, pursuant to Chapter 21.26.

    (Ord. O-1-04 Revised (part), 2005)

(Ord. No. O-25-11 Amended, § I, 6-10-2013; Ord. No. O-15-14 Amended, § I, 7-14-2014)